Dusting due to surface abrasion is eliminated 100% with the use of DynaCreteŽ PIM+. |
Fact:Floors, pavements, and structures are subjected to abrasion; therefore, in these situations, concrete must have a high abrasion resistance. Test results indicate that abrasion resistance is closely related to the compressive strength of concrete. Strong concrete has more resistance to abrasion than does weak concrete.*
Treatment with DynaCreteŽ PIM+ gives the concrete 100% improvement against dusting due to abrasion. *ORF Method. Concrete Dusting, (small particles of the surface grinding away), can be caused by any vehicular, foot, or machinery traffic over the concrete surface. It is a costly foe to efficiency due to the damages it causes to machinery, merchandise, and environmental health. Recommendation:DynaCreteŽ PIM+ causes a chemical reaction to take place with the alkali and lime inside the concrete to form an internal seal. This internal membrane increases the compression strength of the concrete by as much as 23% and surface abrasion is eliminated 100%. Costly floor coverings often used to control dusting, can be eliminated by the use of DynaCreteŽ PIM+. DynaCreteŽ PIM+ will not wear, chip, or peel like most surface coatings, because there is no membrane to chip or peel. DynaCreteŽ PIM+ forms an interior seal with a protection depth of ˝ to 1˝ inches inside the concrete. In factory or warehouse situations where equipment is dragged and tools dropped on the concrete, it is an economic necessity to use a product that does not chip, peel, or wear off. Related Articles: |
